Frog Gig (1 Inch)

About This Model

This 1 inch frog gig head is practical 3D printed gear built for reliable small game hunting. It fits over 1 inch PVC pipe and locks down with a bolt for a tight, steady connection. The barbed prongs are shaped to hold frogs and similar game without slipping free. It’s a pre-sliced file, ready-to-print with no tuning or setup, so you can make one and keep it ready in your gear. It fits well in survival gear kits, vehicles, or homesteading setups where food gathering tools matter. Use it around ponds, creeks, or marsh edges where visibility is low and control counts. The design holds up to repeated use within its limits when mounted properly. For field use and off-grid hunting, it’s a straightforward outdoor tool that does its job.